Bodyworx J4715, Руководство пользователя

Страница: 20 / 32


MAINTENANCE
• Warning : To prevent electrical shock, be certain the treadmill is turned off and unplugged for cleaning or routine maintenance.
• Important : Never use abrasives or solvents to clean the treadmill. To prevent damage to the computer, keep liquids away and keep it out of direct
sunlight.
• After each workout : Wipe off the console and other treadmill surfaces with a clean, water dampened soft cloth to remove excess perspiration.
• Weekly : Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes may get into the belt and eventually make its way
underneath the treadmill. Vacuum underneath the treadmill once a week if used.

BELT ADJUSTMENT
You may need to adjust the running belt during the first few weeks of use. All running belts are properly set at the factory. It may stretch or be off-center
after use. Stretching is normal during the break-in period.
ADJUST THE BELT TENSION
If the running belt feels as though it is “slipping” or hesitating when you plant your foot during a run, the tension on the running belt may have to be
increased.
TO INCREASE THE RUNNING BELT TENSION:
A) Place 6MM inner hexagon spanner on the left belt tension bolt located inside the rear end caps. Turn the inner hexagon spanner clockwise 1/8
turn to draw the rear roller and increase the belt tension.
B) Repeat STEP A for the right belt tension bolt. You must be sure to turn both bolts the same number of turns, so the rear roller will stay square
relative to the frame.
C) Repeat STEP A and STEP B until the slipping is eliminated.
D) Be careful not to tighten the running belt tension too much as you can create excessive pressure on the front and rear roller bearing that will
result in bearing noise from the front and rear rollers.
TO DECREASE THE TENSION ON THE RUNNING BELT, TURN BOTH BOLTS COUNTER CLOCKWISE EVENELY.
- 17 -