body Power PBC5380, Руководство пользователя

Страница: 7 / 16

PBC5380 Page 6
Assembly STEP 2
On the left side, align one left Rear Upright Frame (#20) to
Rear Cross Frame (Bottom) (#19) . Please pay special
attention and make sure the Small Hole is facing the inside
as shown on illustration. Attach them together with the
reinforcement plates by using four Hex Bolts (#22) secured
by four Washers (#24) and four Nylon Nuts (#26) .
Align the left Front Upright Frame (#17) to the Left Bottom
Frame (#01) . Attach them together as shown in the
diagram by using two Reinforcement Plates 1 (#16) , and
four Hex Bolts (#23) secured by four Nylon Nuts (#26) .
Repeat this process on the right side.
Small Hole should be
facing inside
Big Hole should be
facing outside
Hardware Required
NOTE:
To avoid misalignment due to over-tightening,
please do not use a wrench at this time.
Hand-tightening for now will help ensure easy
assembly.
Wrench-tightening should be performed after all
parts are assembled to ensure all nuts, bolts, and
parts are tightly secured before use.
LEFT
RIGHT
#26
Nylon Nut (M10)
[16 Pieces]
#23
Hex Bolt (M10x95 mm)
[8 Pieces]
#24
Washer (M10)
[8 Pieces]
#22
Hex Bolt (M10x70 mm)
[8 Pieces]