PBC5380
Page 12
Safety and Maintenance
•
Make sure all nuts, bolts, and screws are tightened prior to use.
•
Be sure that all adjustment locking devices and safety devices are properly engaged prior to use!
•
Never over-tighten the above-mentioned devices and parts to avoid damage to the unit.
•
Check for loose parts and components and make proper adjustments prior to use.
•
Check to see if there are any tears or bends in the welding or metal prior to use. If tears or bends are found,
DO NOT use the unit and contact our CUSTOMER SUPPORT.
•
Extreme care must be taken to not allow your feet, fingers, hai , clothing, and/or any loose items to be snagged into
any portion of the unit when the unit is in use. Failure to follow these instructions could result in serious injury.
•
This piece of equipment includes four (built-in) Floor Anchors
(#39)
that allow the user to mount the equipment to the
floo . Floor mounting is optional but highly recommended as it increases stability in pieces of equipment that are used
often or used with heavy weight. Mounting hardware is NOT PROVIDED, but can easily be obtained at your local
hardware store. Find a qualified store employee to help you select the proper type of hardware for your type o
installation, whether it be into concrete, a wooden subfloo , etc.
•
Please review all safety instructions and warnings in this entire Owner’s Manual, as well as any safety/warning labels
affixed to the product before use.
•
To avoid rust or corrosion to the metal parts caused by moisture and sweat, we advise wiping and drying the unit with
a dry absorbent towel after each workout session.
•
Do not use solvent cleaners. If you are in any doubt, do not use your cleansing product; contact
CUSTOMER SUPPORT.
•
The specific parts on your unit which may see possible signs of wear after prolonged use are listed as follows (please
check these parts before each use):
Left/Right Full-length Safety Rod
(#06/#07)
, Left/Right Weight Bar Safety Catches
(#10/11)
, Left/Right Pull-Up Bar
(#14/15)
, Left/Right Dip Bar
( #8/9)
•
For any replacement warning labels, please contact our CUSTOMER SUPPORT at :
1 (888) 266-6789
or
1 (909) 598-9876
, or mail in a written request to:
Hupa International,
Inc.
21717 Ferrero Parkway
Walnut, CA 91789
More detailed information about how to reach our CUSTOMER SUPPORT may be found on the General Information
page of this manual.
Safety & Warning
Maintenance & Care
