PBC5380
Page 8
Assembly STEP 4
A.
Using the diagram for reference, on the left side,
align Left Pull-up Bar
(#14)
to Front Cross Frame
(Upper)
(#05)
and Reinforcement Plate 2
(#18)
.
Attach them together by using one Hex Bolt
(#21)
from the rear, and one Hex Bolt
(#22)
from the front
and
secured
with
one Nylon Nut
(#26)
.
B.
Repeat Step A. on the right side using Right Pull-up
Bar
(#15)
.
C.
On the left side, align three Weight Plate
Holders
(#13)
to the side holes on the left Rear
Upright Frame
(#20)
. Attach them together by using
three Hex Bolts
(#21)
through three Large
Washers
(#25)
.
D.
Repeat Step C. on the right side.
Hardware Required
NOTE:
To avoid misalignment due to over-tightening,
please do not use a wrench at this time.
Hand-tightening for now will help ensure easy
assembly.
Wrench-tightening should be performed after all
parts are assembled to ensure all nuts, bolts, and
parts are tightly secured before use.
#26
Nylon Nut (M10)
[2 Pieces]
#25
Large Washer (M10)
[6 Pieces]
#22
Hex Bolt (M10x70 mm)
[2 Pieces]
#21
Hex Bolt (M10x
2
5
mm)
[8 Pieces]
B
D
C
A
LEFT
RIGHT
