Form No. 1045-69 r5/21/14 © 2014 Bobrick Washroom Equipment, Inc. Printed in U.S.A.
Finish Face of Floor
Phenolic Shower Seat
Masonry Wall
Bracket
''D''
Fig. 1c: Shower Seat 1080/1180 Series
A. Mark holes on one side of shower seat using mounting
brackets as templates. Mounting holes to be 3"
maximum from each end of seat.
B. Drill #19 x 3/8" deep holes in seat.
Caution: Do Not
Drill Through.
C. Attach brackets with #1002499 screws.
D. Support seat so that height of seat complies with local
building codes. Seat must be level with the floor in all
directions and mounting brackets must be flat against
the panel.
E. Using brackets as templates mark and drill #19
(4.2mm) into wall 2" (50mm) deep.
F. Attach brackets to wall with #1002495 screws.
G. Test and examine seat and fasteners and brackets to
make sure there are no loose parts.
STEP 1
BENCH/SHOWER SEAT INSTALLATIONS
A. Remove any exposed labels from the components.
B. Clean surfaces as needed. CAUTION: Do not use cleaners containing acid on Bobrick toilet compartments.
For example, tile cleaners containing acid may attack the stainless steel hardware.
For Bobrick recommendations, refer to Bobrick Advisory Bulletins Nos. TB-21 and TB-60.
FINISHING AND CLEANUP
Page 9
