Blue Seal Evolution G504, Инструкция по установке и эксплуатации

Страница: 15 / 31

13
Oven Pilot Ignition
1. Open the oven door. Depress the thermostat control
knob and rotate anti-clockwise to the ‘PILOT’ position.
2. With the gas control knob depressed, press the piezo
ignition button to ignite the pilot burner. Repeat Items 1
to 2 until the pilot is lit.
3. Release the gas control knob approximately 10-20
seconds after lighting the pilot, until the pilot
thermocouple is heated up by the pilot flame.
4. The pilot should now remain alight. If the pilot does not
light, repeat Items 1 to 3 above.
5. View the pilot burner through the holes in the front of
the burner box with the oven door open. See Fig 4.
Oven - Main Burner / Thermostat
1. With the pilot burner alight, rotate the thermostat control knob anti-clockwise to the desired oven
temperature setting required, this will regulate the gas supply to the burner.
2. To turn the main burner ‘OFF’, simply turn the thermostat control knob clockwise to the ‘OFF’
position.
Turning the Oven to ‘Standby’ (Pilot ‘ON’ Only)
1. To turn off the oven burner / heating, set the oven thermostat to the ‘PILOT’ position, this will turn
the oven ‘OFF’, but leave the oven pilot burner ‘ON’.
2. In this position the pilot burner will remain alight, but the main burner will not operate until the
thermostat control knob is set to a temperature.
3. If pre-heating of the oven is required, set the thermostat control knob to temperature 190°C and
allow 20 minutes before cooking in the oven to allow the oven to warm up.
Oven ‘Shut-Down’
1. To turn the oven off to the ‘PILOT’ position only, rotate the thermostat control knob clockwise until
the pilot position is reached. In this position only the pilot burner will remain on.
2. To ‘Shut Down’ the oven, depress and turn the thermostat control knob to the ‘OFF’ position. This
will turn ‘OFF’ the oven and extinguish the pilot burner. To re-light the pilot burner, refer to ‘Oven
Pilot Ignition’ in this section.
Operation
Pilot Burner
viewing holes
Fig 4
! IMPORTANT
DO NOT USE aluminium foil or trays directly on the cast iron sole plate(s).
NEVER block or cover the openings on each side of the sole plate(s).
Should any abnormal operation like;
- ignition problems,
- abnormal burner flame,
- burner control problems,
- partial or full loss of burner flame in normal operation,
be noticed, the appliance requires IMMEDIATE service by a qualified service person and shall not
be used until such service is carried out.
IMPORTANT