Outdoor LP Gas Pizza Oven & Grill
Model No. GOT1509M
8
6. Push and turn any control knob to . The burner
should light. If it does not, repeat up to three
times.
7. If ignition does not occur in 5 seconds, turn
burner control knob “ OFF,” wait 5 minutes, and
repeat lighting procedure.
8. If igniter does not light burner, use a long lit match
to light burners. Access the burners through the
cooking grid and heat plates. Position long lit
match near side of burner (Figure 5).
9. After lighting, observe the burner flame. Make
sure all burner ports are lit and flame height
matches illustration (Figure 6).
W
CAUTION: If burner flame goes out
during operation, immediately turn
the control knobs to the “ OFF”
position, turn the LP gas tank valve to
“CLOSED” and open lid to let the gas
clear for 5 minutes before re-lighting.
Turning Off
1. Turn LP gas tank valve to “CLOSED.”
2. Turn all control knobs clockwise to the “ OFF”
position.
Note: A “poof” sound is normal as the last of the
LP gas is burned.
3. Disconnect LP gas tank per “Disconnecting LP
Gas Tank” section.
To Use as a Pizza Oven
W
CAUTION: Always open oven door
carefully and slowly as heat and
steam trapped within grill can cause
severe burns.
W
CAUTION: Always wear protective gear
(pot holders, gloves, BBQ mittens, etc)
when opening and closing the oven
door.
1. Remove warming rack.
2. Place pizza stone on cooking grid.
3. Light grill per “Lighting Instructions” section.
4. Wait until pizza oven is at desired temperature.
5. Wearing heat resistant gloves, open the oven door
(Figure 7).
6. While wearing heat resistant gloves, use a pizza
peel to carefully place the pizza on the pizza
stone.
7. While wearing heat resistant gloves, close the
oven door (Figure 8).
8. Cook food until proper cooking time or desired
temperature is reached.
Note: Cooking times with this product may vary
from cooking times for microwaves and stoves.
9. Wearing heat resistant gloves, open the oven door.
10. While wearing heat resistant gloves, carefully
remove the pizza with the pizza peel.
11. Turn off per “Turning Off” section.
W
CAUTION: Always allow the pizza stone
to fully cool before removing it from
the oven.
W
CAUTION: Do NOT place pastries or
cookies directly on the stone; the
butter or fat content will cause the
stone to smoke.
To Use as a Grill
W
CAUTION: Always open grill lid
carefully and slowly as heat and
steam trapped within grill can cause
severe burns.
W
CAUTION: Always wear protective gear
(pot holders, gloves, BBQ mittens, etc)
when opening and closing the oven
door.
1. Remove pizza stone and properly store.
2. Light grill per “Lighting Instructions” section.
3. Wait until grill is at desired temperature.
Figure 6
Burner
Flame
Slight
Yellow
Slight
Blue
Dark
Blue
Checking for Leaks
Burner Connections
1. Make sure the regulator hose and valve
connections are securely fastened to the burner
and the tank.
2. Visually check the connection between the burner/
venturi tube and orifice.
3. Make sure the burner/venturi tube fits over the
orifice.
W
WARNING: Failure to inspect this
connection or follow these instructions
could cause a fire or an explosion
which can cause death, serious bodily
injury or damage to property.
4. Please refer to diagram for proper installation
(Figure 1).
5. If the burner/venturi tube does not rest flush to the
orifice, as shown, please contact 1.800.762.1142
for assistance.
Tank/Gas Line Connection
1. Make 2-3 oz. of leak detection solution by mixing
one part liquid dishwashing soap with three parts
water.
2. Make sure control knobs are in the “ OFF”
position (Figure 2).
3. Connect LP gas tank per “Installing LP Gas Tank”
section.
4. Turn LP gas tank valve to “OPEN.”
5. Spoon several drops of solution, or use a squirt
bottle, at all “X” locations (Figures 1, 3 and 4).
a. If any bubbles appear, turn LP gas tank valve to
“CLOSED,” reconnect and re-test.
b. If you continue to see bubbles after several
attempts, turn LP gas tank valve to “CLOSED”
and disconnect LP gas tank, per “Disconnecting
LP Gas Tank” section. Contact 1.800.762.1142
for assistance.
c. If no bubbles appear after one minute, turn LP
gas tank valve to “CLOSED,” wipe away solution
and proceed.
First Use
1. Make sure all labels, packaging and protective
films have been removed from the grill.
2. Remove manufacturing oils before cooking on
this grill for the first time by operating the grill
for at least 15 minutes on (HIGH) with the lid
closed. This will “heat clean” the internal parts and
dissipate odors.
Lighting
W
CAUTION: Keep outdoor gas cooking
appliance area clear and free from
combustible materials, gasoline and
other flammable vapors and liquids.
W
CAUTION: Do NOT obstruct the flow of
combustion and ventilation air.
W
CAUTION: Check and clean burner/
venturi tubes for insects and insect
nests. A clogged tube can lead to a fire.
W
CAUTION: Attempting to light the
burner with the lid closed may cause
an explosion.
W
CAUTION: Always place your oven &
grill on a hard, non-combustible, level surface. An asphalt or blacktop
surface may not be acceptable for this purpose.
W
CAUTION: Move gas hoses as far away as possible from hot surfaces
and dripping hot grease.
W
CAUTION: The gas hose should be arranged so that it will not be pulled
on or tripped over.
1. Open lid.
2. Check for obstructions of airflow to the burners. Spiders, insects and webs can clog the
burner/venturi tube. A clogged burner tube can lead to a fire.
3. Control knob must be in the “ OFF” position (Figure 2).
4. Connect LP gas tank per “Installing LP Gas Tank” section.
5. Turn LP gas tank valve to “OPEN.”
Operating Instructions
Figure 1
LP Gas
Valve with
Orifice
LP Gas
Connection
Burner/
Venturi
Tube
Figure 2
OFF
ARRÊT
Figure 3
X
X
X
X
X
Figure 4
Figure 5
Match
Figure 7
Figure 8
