Blue Coat SG210 series, Руководство по установке

Страница: 31 / 54

Chapter 2: First-Time Configuration 31
Logging in to the SG210 CLI
Connect to the SG210 CLI using a direct serial connection or an SSH client, such as PuTTY or F-Secure. To
connect to the SG210 CLI using Telnet, you must first enable the Telnet Console. Refer to Volume 3: Proxies
and Proxy Services of the
Blue Coat ProxySG Configuration and Management Guide Suite .
Note: The CLI enable password restricts access to the privileged mode configuration options.
To log in to the SG210 serial console using a direct serial connection:
1
To set up the serial connection, complete steps 1 through 3 in the section “Using the Serial Console to
Configure Initial Settings” on page 15.
The following text displays:
Figure 2-18: Serial Console Login Page
2
Enter 1 to access the Command Line Interface.
3
At the command prompt, enter
enable
, then enter the enable password that you configured during
initial configuration:
SGOS> enable
Enable Password:
SGOS#
You are now in privileged mode.
4
At the privileged-mode command prompt, enter configure terminal to configure SG210 settings:
SGOS# configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
SGOS#(config)
Refer to the Blue Coat ProxySG Configuration and Management Guide Suite or the Blue Coat ProxySG Command
Line Reference for information about using the CLI to configure the SG210.
Welcome to the ProxySG Appliance Serial Console
Version: SGOS 5.2.0.4, Release id: 29708
------------------------- MENU---------------------------
1) Command Line Interface
2) Setup Console
--------------------------------------------------------
Enter option: