Blue Bird HO35C, Инструкция по использованию

Страница: 22 / 32

INSTRUCTIONS FOR THE USE OF THE BRUSHCUTTER
GB-7
3.3 For all models
Fig. 7
Safety guard:
(Fig. 7). The guard (C) for cutting tool is fixed next to the
gear head (A) through the appropriate support supplied (B). The fixed
distance of the shelter from the cutter, in accordance with CE regulations,
is ensured by fixing the guard to the shaft with the M5x14 screw supplied
(Part D). The type of shelter to be mounted should be chosen according to
the tool used to cut. The dimensions of the fixing screws are specified in
the drawing.
Safety belts
:
-
Double shoulder strap
: the safety belt is composed of a shoulder strap
with a fixed shoulder piece and a side protection with a support clip. The
length of the belt must be adjusted to your height using the pass-through
buckle positioned near the shoulder element. Position the safety belt on
your left shoulder so that the side protection clings to your right side and
that you can quickly discard the machine by unsnapping the clip buckle
positioned at the end of the side protection in conformity to CE standards
whenever immediate risks arise.
-
Single shoulder strap
: the safety belt is composed of a fixed shoulder
element and a machine support clip connected directly to the clip buckle
(no side protection is provided) that permits the machine to be
immediately discarded. This safety belt must be positioned as explained
above.
Balancing
: before starting to work, adjust the shoulder strap in order to balance the weight of the device by following
the instructions below. Then put on the shoulder strap and clip the machine to its attachment. For machines equipped
with nylon wire cutting heads, adjust the shoulder strap in such way that the distance between the ground and the
closest point of the cutting element ranges between 0 - 300 mm. For machines equipped with cutting disks, adjust the
shoulder strap in such way that the distance between the ground and the closest point of the blade ranges between 100 -
300 mm.
Backpack
: in all models equipped with flexible shaft, the engine is mounted in a backpack equipped with two
adjustable shoulder straps. The left strap is equipped with a clip buckle that permits the backpack and the machine..
3.4 Fastening of cutting organs
Fig. 8
Fig. 9
Safe and economical operation requires the type of cutting accessory
mounted to be the ,most appropriate for the use in question (Fig. 8). The
right type of cutting accessory for your specific need and the model you
have chosen will be provided either as standard or as an optional.
IMPORTANT : the appropriate safety guard required by CE
standards (Fig.10) must be applied for each tool mounted, and
in the case of cutting heads, use only the nylon wire
recommended by the manufacturer (never use wire made of
steel or other materials!). Make sure that all tool mounted are
original, bear the seal of approval, and are recommended by
the manufacturer.
For machines equipped with nylon wire cutting heads, the machine can be
used either in the version with the grip or the version with the handlebar.
For all other types of cutting element, use the version of the machine with
the handlebar.
Proceed as follows for the assembly of the cutting accessory with the
respective safety guards:
Cutting heads with nylon wire
(Fig. 9)
- Fastening: block the rotation of the threaded shaft on the gear housing by
inserting a screwdriver or an Allen wrench through the hole present on the
gear case aligned to the one on the centering ring. Then screw clockwise
until the head is completely tightened to the shaft.