25
AQT8-QAM/IP
User Manual
I
P Output:
allows user to Enable/Disable each IP Output.
NOTE
:
When an “IP Output” is Disabled, the “Main > Status” screen will show
the disabled output highlighted in red. (See Figure 6.2 for details)
ASI Output:
allows the user to select the IP output which will be present at the front panel ASI output.
Destination IP:
allows user to assign the IP address of the recieving equipment.
Encapsulation:
there are two available options (RTP & UDP) , the user must select the one that matches the protocol
used by the receiving equipment.
Destination Port:
user must enter IP Port of the receiving equipment. The range is 1 to 65535. (Factory Default:
50000)
Source Port:
must enter IP Port of the equipment that Input IP source is generated from. The range is 1 to 65535.
(Factory Default: 50000)
NOTE: Port number is recommended to be from 49152 to 65535 and unique for each IP output.
Reason: Port 1-1023 and 1024-49151 are the Reserved Ports and the Registered Ports, respectively.
Time to Live:
is a limit setting on the time that an IP packet can exist in an IP network. The value is set by the sender
of the packet, and reduced by every host on the route to packet’s final destination. If the Time to Live reaches zero
before the packet arrives at its final destination, then the packet is discarded. The purpose of this field is to avoid an
undeliverable packet from circulating on an IP network perpetually. The range is 1 to 255. (Factory Default: 128)
Stuffing:
Null packets are inserted to ensure that the TS bitrate assigned in of Section 6.4 remains constant.
Options are Enable and Disable. It is advisable to Disable stuffing when only GigE output is used to help reduce
network traffic.
6.5 "Main > IP Output Config" Screen
The “Main > IP Output Config” screen (Figure 6.5) is a “read and write” screen where the following parameters are
configured and displayed for each IP Output configuration. This tab is only displayed when the output mode (see section
6.6) is active.
Figure 6.5 - "
Main >
IP Output Config" Screen
3
4
5
6
7
8
1
2
1
2
3
4
2
5
6
7
8
Remember
to
click
on
the
SAVE
button
to
apply
the
new
values/configurations.
When output mode is disabled, the "IP Output Config" tab and "MPTS Output Config" tab will not
appear on web page. The unit must have at least 1 output enabled in order to use the tabs.
Содержание AQT8-IP
Страница 40: ...40 AQT8 QAM IP User Manual Notes ...
Страница 41: ...41 AQT8 QAM IP User Manual Notes ...
Страница 42: ...42 AQT8 QAM IP User Manual Notes ...
