Blomberg WM 26110 NBL00, Руководство пользователя, Страница: 30 / 40

30
EN
There is water
coming from the
bottom of the
washer.
Inlet hose connections may be
leaking.
Be sure the strainers and rubber seals of the
water inlet hoses are solid and securely fitted.
End of the drain hose may be
loosely inserted into the waste
pipe or sink.
Tightly attach the drain hose to the waste pipe or
sink (See “Installation Instructions, Drainage”).
House drain may be clogged.
If the house drain pipes are clogged, call a
plumber for assistance.
Filter cap of the drain pump
may not be properly fitted.
Make sure that the pump filter cap is tightly
closed.
Hose connections inside the
washer may be leaking.
Internal hose connections (e.g. dispenser hoses,
drain system) should be checked by a service
technician.
Washer fills with
water when
a process is
cancelled.
There may be hot water inside
washer.
For safety reasons, water should be cycled in and
out a couple times.
Time delay function
does not work.
Door may not be closed
properly.
Close the loading door.
The door will not
open.
Water level might be above the
lower level of the door.
Run “Drain” , “Spin” or “Drain&Spin” program.
Washer might be heating up
the water or it may be at the
spinning cycle.
Wait until the process is over.
Due to electrical safety
mechanism, the door can only
be opened a few minutes after
the program has stopped.
Wait until the process is over.
The door will not
lock.
Door is not properly closed/
Door hinge is not aligned with
lock switch.
Check for any bulky or large items obstructing the
door to be closed.