Installation
10
Final Check and Adjustments
BEFORE SWITCHING THE APPLIANCE ON
Before applying power to the unit for the first time,
check for the following conditions:
j
The unit is level.
j
All āelectricalā safety provisions have been adĆ
hered to and the electrical connections are
correct.
j
The circulation blower wheels should turn
counterĆclockwise: check rotation from inside
the oven cavity.
j
Water is connected, turned on and all of the
connections are water tight.
j
Grease filters are in their proper positions
j
The transport cart is inserted into the cooking
cavity. When the cart is not inserted into the unit,
water can spill onto the floor causing it to beĆ
come slippery. If the door will not close properly,
use the following adjustment procedure.
NOTE: The first time the unit is turned on, or after
the unit has been OFF for 5 hours and then
turned on, āit āwill automatically flush the
steam generator for a period of 75 secĆ
onds. The steam generator will then fill to
the proper water level. The unit is now
ready for operation.
DOOR ADJUSTMENT
The hinges may be adjusted using the following
procedure:
1. Adjust the top hinge plate by loosening the
three mounting bolts on the top right corner of
the unit.
2. Adjust the bottom hinge pin by loosening the
mounting bolt located under the bottom hinge
plate on the lower right corner of the oven.
3. Adjustā the hinges āso āthatā the door back and
the unit face are parallel.
4. Tighten the bolts so that there is no further
movement.
5. The āadjustment āis ācorrect āwhen āthe ādoor closes
firmly and no steam leaks from the gasket.
The hinges can also be adjusted as follows:
1. Adjust the door catch by loosening the four
mounting screws located on the inside surĆ
face of the oven door.
2. The āadjustment āis ācorrect āwhen no steam
leaks from the gasket. DO NOT over comĆ
press the door gasket. When closed the door
should slightly compress the door gasket.
COSĆ20G Shown
Oven
Door
Oven
Door
Figure 5
