The carrier rod is made from aluminum pipe. The large fixing ring that is mounted on its lower
end is used for connecting the pipe with the intermediate connecting rod.
The handle is part of the carrier rod and is coated with soft and solid foam.
For better stability, the armrest is made from aluminum. It has a strap for better fixation to the
elbow during a search.
Under the armrest is mounted the electronic block. It consists of a plastic box with aluminum
panels, in which are mounted the electronics and the LiPo battery of the metal detector. On the
front panel, back panel and the lid of the electronic block are mounted the setting, indication
and maintenance bodies.
The intermediate connecting rod is made from aluminum pipe. At its upper end it is connected
by the large fixing ring to the carrier rod – it fits into it, while at its lower end it is connected to
the lower connecting rod by the small fixing ring.
The lower connecting rod is made from carbon, so that it does not interfere with the normal
working mode of the metal detector. At its upper end it is connected by the small fixing ring to
the intermediate connecting rod – it fits into it, while at its lower part ends with a plastic
nozzle by which is connected to the search coil.
To not affect the intermediate connecting rod on the work of the metal detector, because it is
made from aluminum, ie metal, it is recommended that the lower connecting rod to be
inserted in the intermediate connecting rod to a situation in which remain at least 20-30
centimeters away from the top of the search coil to the small fixing ring.
To quickly and easily set the desired from the user length of the carrier construction, the fixed
mechanisms type bud, available on the lower connecting rod and on the intermediate connecting
rod, are inserts respectively on the holes located at a different levels on the intermediate connecting
rod and on the carrier rod.
The search coil is connected to the plastic nozzle of lower connecting rod via the plastic bolt
and nut. Between the ears of the search coil and the plastic nozzle of the lower connecting rod,
put the included in the standard package emollient and fixed rubber type washer, which
prevent the ears of the search coil from deformation and breakage when tightening. Thus, the
search coil can be installed and removed repeatedly from the lower connecting rod.
The search coil, via the connector of the connecting shielded cable, is connecting to the connector
COIL mounted on the back panel of the electronic block.
If necessary to change the position of the search coil to the lower connecting rod (change the
working angle during working with the metal detector or folding to carry and transport), is
necessary to loose coupling fixing by a plastic bolt and nut and after the new setting, it can be
tight to be fix the search coil in the new position.
The changing of the working angle in tight situation can lead to breakage of the ears of the search
coil, deformation of the ears and the search coil or a fatal frustration of the search coil and changes
of its parameters.
When changing the working angle of the search coil to the lower connecting rod, must be
monitored for the presence of an advance of the bottom of the connecting shielded cable of the
search coil to keep it stretched too much as this can cause damage its.
Recommended always to provide a small advance of the connecting shielded cable of the search coil
in its lower part, just above the nozzle during which it comes out of the search coil.
The coil cable ends with a connector and there is a single correct position for it so that it could
be plugged in the connector COIL, which lies on the back panel of the electronic block. In this
position, the hollow cursor of the cable connector falls in with flange cursor of the connector
COIL, and when inserted, the cable connector enters into the connector COIL at a depth of
around 10 mm. After the cable connector is plugged in, it is screwed to the connector COIL by
the means of the available metal stopping nut, used as a shield.
The incorrect insertion and/or the application of a brute force while incorrectly inserting the
connector of the search coil could lead to damaging of the metal detector.
BLISSTOOL LTC64X
- User Guide (version EN201405101504)
Page 14 of 42
