9.13. PHONES connector
The PHONES connector serves for plug to metal detector, if necessary, stereo
headphones with 6.35mm (1/4") stereo jack. When the headphones are
plugged in, the loudspeaker is switched off automatically and the metal
detector’s sound is heard only in the headphones. To make this possible, in
advance, by pulling back, from the connector PHONES must be removable the
protective cap, designed to prevent from corrosion, contamination and water
its pins.
ATTENTION: To protect your hearing, it is desirable before turning stereo
headphones to BLISSTOOL LTC64X, to reduce the volume of the metal
detector by VOLUME potentiometer, as put it between levels "2" and "3".
The use of stereo headphones with set high volume of the sound by the VOLUME potentiometer can
seriously damage your hearing!
In order to protect BLISSTOOL LTC64X from damage, is recommended the inclusion and exclusion
of the jack of the stereo headphones to/from the PHONES connector, to be carried in power-off
condition of the metal detector! Furthermore, the jack of the stereo headphones should be excluded
from connector PHONES also in transportation of the metal detector, again to prevent damage!
The use of stereo headphones while using the metal detector has many advantages:
- the stereo headphones block outside noise such as wind and traffic and allow you to hear
better, even the weakest signals from deeply buried metal objects;
- through their use, the sound of your metal detector will not interfere with other searchers
around you;
- their use, provides reduced power consumption from the LiPo battery of the metal detector,
leading to an extension of its life.
When leaving of the metal detector on the ground, care must be taken during the PHONES connector
in its electronic block to not enter sand, dust or moisture.
9.14. COIL connector
The COIL connector serves for connection of the search coil of the metal
detector to its electronic block.
For quality work of the metal detector, connector COIL and the connector of
the search coil which includes in it, must be kept from dust, dirt, moistening
and wetting.
9.15. BAT LOW LED
The BAT LOW LED shows the available charge in the LiPo battery. When this
LED lights up, it is a signal for low battery.
In very low battery, from the loudspeaker of the metal detector began to hear
periodic pulled sounds and the metal detector stops working or not working
correctly.
9.16. CHARGE connector
The CHARGE connector serves for connection of the automatic LiPo battery
charger to the built-in LiPo battery of the metal detector. To make this
possible, in advance, by pulling back, from the connector CHARGE must be
removable the protective cap, designed to prevent from corrosion,
contamination and water its pins.
The charging of the LiPo battery is carried out according to the description in 13.
BLISSTOOL LTC64X
- User Guide (version EN201405101504)
Page 30 of 42
