8
This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
To replace the door glass:
1)
Remove the six M6 size Allen key screws securing the
glass retainer to the door with the supplied Allen key.
2)
Gently lift the glass retainer up and out, taking
careful note that the glass may still be intact in
the retainer and potentially could fall out.
3)
Flip the retainer over, remove the old glass panel.
4)
The new door glass panel should have been
supplied with a length of adhesive glass seal. Peel
back the backing on the tape, and run it along the
edges of the glass panel, folding it equally over
each side so as to create a padded border around
the edge of the glass.
5)
Fit the new glass into the glass retainer, relocate
the retainer so that all six threads can be seen
through the holes, before fastening the six
screws.
6)
Dispose of the old glass in a responsible manner.
This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
1)
Remove any old seal from the door.
2)
Clean out the groove in the door that the seal was
bedded in using a flat-end screw driver or equivalent.
3)
Run a thin bead of clear roof and gutter silicone along
the groove.
4)
Starting at one end, press the new door seal into the
groove on the door.
5)
Refit the door if it has been removed and close.
Over time, the door seal can become compressed resulting in
a less than adequate seal between the door and the front
edge of the firebox. For example, if the wood burns unusually
fast even with the air slide shut, it may mean that there is an
air leak around the door.
In this situation, the door seal does not necessarily need
replacing rather adjustment of the door handle can tighten
the seal.
5. FITTING A NEW DOOR GLASS
6. FITTING A NEW DOOR SEAL
7. DOOR HANDLE ADJUSTMENT
Allen key screws Hinge bracket
Adhesive glass seal Glass
Glass retainer Door Rope
