9
There are two ways to tighten the door:
1)
Adjust door latch bracket – the bracket on the right side
of the firebox upon which the door handle latches onto
can be gently tapped with a hammer. Alternatively,
loosen the two M6 Allen key screws, relocate the
bracket into the desired location, and then fasten the
two screws. Close the door to test if any improvement in
the door closing firmly.
2)
Remove washer from door handle assembly:
a)
Remove the nut from the door handle shaft inside
the door.
b)
Remove the latch and remove one washer.
c)
Replace the latch and then place the removed
washer on the other side.
d)
Refit the nut. Do not over tighten otherwise door
handle will not turn easily.
If door seal is still not tight enough remove another washer or
replace door seal.
The frequency used by the fan remote control can be changed
if interferences are experienced in the home.
NOTE: Unplug the power lead before proceeding.
Remote Control Receiver
The remote control receiver has four tiny switches on the side,
as seen in the photo below. Change the switch setting to
something different than current setting. Remember this
switch setting as it will need to be replicated on the fan
controller.
To access the remote control receiver: -
B600 & B900 Models – located in the base unit, in
the rear panel on the left hand side, removed via two
screws with a M6 Allen key.
B605 & B905 – located underneath at the rear of the
base unit in a steel cabinet that can be removed via
two screws with a M6 Allen key.
Fan Controller
Remove the battery cover and batteries. With a small
screwdriver or equivalent, change the switch setting to be the
same as that on the remote control receiver.
Replace the batteries and cover, plug in the power lead and
test the fan with the different frequency setting. If
interferences are still experienced, repeat the steps with
another switch setting configuration.
Firebricks
B600 & B605
7 @ 200mm x 145mm x 25mm
2 @ 255mm x 175mm x 25mm
1 @ 255mm x 85mm x 25mm
B900 & B905
7 @ 255mm x 175mm x 25mm
3 @ 285mm x 175mm x 25mm
Baffle Plate
B600 & B605
490mm x 230mm x 6mm
B900 & B905
590mm x 286mm x 6mm
Ash Deflector
B600 & B605
495mm x 130mm x 5mm
B900 & B905
595mm x 130mm x 5mm
Door Seal
B600 & B605
1600mm x 16mm round
B900 & B905
1900mm x 16mm round
Glass Seal
B600 & B605
1550mm x 19mm x 3mm flat adhesive back
B900 & B905
1840mm x 19mm x 3mm flat adhesive back
Brick Retainer Brackets
B600 & B605
495mm x 290mm
B900 & B905
595mm x 320mm
Door Glass
B600 & B605
483mm x 253mm x 5mm pyro ceramic
B900 & B905
583mm x 303mm x 5mm pyro ceramic
9. REPLACEMENT SPARE PARTS LIST
8. CHANGE FAN CONTROLLER FREQUENCY
