Blaze King APEX CBT, Руководство по установке, эксплуатации и обслуживанию для пользователей

Страница: 13 / 45

Version 1.04
March 2011
APEX cbt Page 13
www.blazeking.com
Apex CBT as independent furnace:
When the blower is installed on the left side of the Apex CBT, the bypass handle needs to be moved to
the right side (see page 14), so if possible, install the blower on the right side.
Install the blower more to the front of the unit as that is where most of the heat is. When using the
VB1000 blower cut an opening 13 1/4” W x 11 13/16” H in the side panel about 9” from the front
(Distance A, see fig. 4 ). Check the height of the hole with the blower. The side panel can be taken off, it
might be easier to cut the opening that way.
DO NOT USE INTERCONNECT DUCT ELBOWS THAT HAVE AN INSIDE RADIUS OF LESS
THAN 6" (150mm.). THE WARM-AIR SUPPLY OF THE APEX FURNACE SHALL NOT BE
CONNECTED TO THE COLD-AIR RETURN INLET OF THE EXISTING OR ALTERNATE
FURNACE. THE POSSIBILITY EXISTS THAT THE COMPONENTS OF THE EXISTING OR
ALTERNATE FURNACE MAY OVERHEAT, CAUSING THE CENTRAL FURNACE TO
OPERATE OTHER THAN INTENDED.
COMBUSTION AIR
Insure adequate combustion air allowing for all other exhausting type appliances in the dwelling (range
hoods, dryers, etc). In airtight houses it is recommended to install a fresh air inlet into the basement
room where the furnace is located.
INSTALLATION INSTRUCTIONS
NOTE: After interconnect duct opening has been cut into the side of the Apex CBT, insulation must be
fastened back to the furnace cabinet all around the opening. Use the metal strips provided to hold the
insulation tightly against the cabinet inside. This will prevent the insulation from dislodging due to blower
induced vibration. (see fig.5 below)
A
W
H
Metal strip
Casing
Insulation
Fig. 4
Fig. 5