Blastrac BMP-4000E, Руководство по эксплуатации

Страница: 22 / 41

22
Procedure when faults occur
 Check the indicators (21-23). After the engine comes to a standstill, the fault will continue to be
displayed by the indicator for approx. another 2 minutes.
 Then the electrical equipment switches off automatically.
 Set the starting key to position "0".
 Turn the starting key back to position "I". The fault display lights up again. Remedy the fault before
making further starting attempts (consult the Hatz manual). The indicator will go out at the next start.
5.2 Leveling the machine (without milling)
12. Make sure the machine is always in a levelled position. You can see this by checking the leveller (9) on
top of the operating panel.
13. To level the machine, you can use both handles (10) & (11).
-Always lift and lower the machine carefully and with low speed.
14. Make sure the switches (12) (13) and the joystick (14) are in the middle position.
(12) “Milling on / - / Milling Reverse”
(13) “Milling / - / Drive”
(14) “Forward / - / Reverse drive”
5.3 Driving the machine (without milling)
15. Make sure there are no other people in an area of 5 meters around the machine.
16. Turn switch (13) to “Drive” so you can only drive with the machine.
-In this position the milling drum cannot turn.
17. By using the joystick (14) you can drive forward and backward. Before u can use
the joystick the bottom part has to be squeezed in, this is a safety device
against unintentionally actuating of the machine.
a. Use the joystick very carefully and slowly.
18. The further the joystick is forward or backward, the faster the machines goes.
a. The “Speed” button (15) does not work when the machine is in “Drive”
mode.