Blastrac BMC-335 ELITE RC, Руководство по эксплуатации

Страница: 4 / 39

4
www.blastrac.eu
1. Introduction
Before use, operators must be provided with information, instruction and training for the use of
the machine and the substances for which it is to be used, including the safe method of removal
and disposal of the material collected. All persons who are working with or maintaining this
machine must read the manual carefully and understand it fully. In case you sell the unit, hand it
on to the next owner.
Keep this manual always with the machine, to enable it to be referred to at any time.
Any other work not covered by this operating manual must not be carried out. Always use
common sense when working with machines.
This machine is designed for industrial use by professionals. Only authorized and trained personnel may
operate this machine. This machine is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge. Blastrac BV offers a course on
the use of the machine in order to make the operating and maintenance personnel familiar with all elements of
the machine.
2. Machine description
The Blastrac multisaw machine BMC-335 is supplied with a 400 Volt electric motor where you can mount
different quantities of saw blades underneath. By changing the pulleys and the belt, the machine can also be
used as a scarifier. The manufacturer will not be liable for damage resulting from incorrect usage, in these
cases the user assumes all risks.
The machine is available with optional remote control system.
The machine is sealed around which makes the use almost dust free when connected to an appropriate
Blastrac dust collector. Due to the fine adjustment and the possibility to lock the height adjustment, the depth
of cutting can be set very precisely, and the same saw depth can be maintained.
Intended use:
The multisaw machine is extremely suitable for removing hard top layers from soft floors or to remove the top
layer from “floating” floors and/or “computer” floors.
Sawing is ideal for removing several millimeters from a concrete floor preparing it to be polished up to the
stones without using an extra scarifier.
The BMC-335 can be used during sawing in the forward or backward driving direction. (Depending on the way
the blades are mounted).
NEVER use the BMC-335 as a scarifier without the proper modifications.
The machine must first be converted into a BMP-335.
This is possible by changing the belt and the pulleys.
If the multisaw machine is converted to a scarifier, it can be used, with the appropriate cutters, for the
following applications;
To roughen concrete
To clean most horizontal surfaces
To remove coatings
To corrugate concrete surfaces
To remove road markings
To make non-slip surfaces
The force of impact of a cutter is controlled by the depth adjustment. With the right depth adjustment, the
best performance is obtained to give a desired result.
With a suitable Blastrac dust collector work can be carried out without causing excessive dust in the work area,
this raises the life span of the machine and protects the health of the personnel.