12
4.4
Drive control
The drive control to move the 2-48DC around can be used as followed:
Connect the dust collector to the power supply.
Make sure the machine stands on its 4 transport wheels, put the 2 swivel castor wheels on the brakes.
Make sure the wheel of the drive unit is loose from the ground.
Follow the next steps to connect the drive wheel to the drive motor.
Connecting the drive motor to the traction wheel
Set the drive speed
knob to the lowest
possible setting,
approximately 0,5.
Open the wheel guard.
Insert the quick release
pin inside the hole.
!WARNING!
Use
only 1 finger
to
press the button of the
quick release pin, and
keep applying
pressure.
Push the green button
“DRIVE”
Danger of crushing!
Use common sense, do
not get distracted
during the activities.
Use your other hand to
operate the drive-
motor handle (10).
1
5
6
When the drive-motor
and wheel are aligned,
the quick release pin
will lock into place.
Close wheel guard.
4
8
2
3
7
Dial for setting the drive speed
Buttons for:
Forward driving (Hold to run)
Overdrive
(Hold to run)
Drive handle (Hold to run) to activate
the drive motor. When the lever is
released the drive motor switches off.
