12
4.5
Transport
When transporting the machine from a vehicle to the work area you can put the machine in its transport
position by using the lever of the lifting mechanism.
To do this, place the lever onto the bracket(2), as shown in the picture. Now press the lever down until the
pivot bracket noticeably locks over its point of rotation.
To place the brackets in operating position, place the lever und move it slowly upward (1), until the pivot
bracket sits close at the height adjustment screw.
WARNING!!
Always put both wheels back to the operating position before turning on the blastwheel motor!
Never start blast cleaning when the wheels are in transport mode!
Be careful! Make sure nobodies feet get under the wheels. Wear appropriate safety shoes when you drive the
machine to or from the work area.
Make sure that no vehicles, such as forklift trucks and other equipment run over the electric cable and the dust
hose.
WARNING!!
Always make sure the blastwheel has come to a complete standstill before moving around the machine in
transport mode!
4.6
Manual moving of the machine
Driving without connected drive motor
When the traction wheel is not connected to the drive motor you can tilt the complete drive unit downwards,
by pressing down on the handgrip of the drive unit. This will lift the blasthouse off the ground and makes it
easier to move the machine around.
WARNING!
Never lift blasthouse of the ground while blasting! This could cause serious injury to yourself and
others around you!
Transport position
Operating position
