Blackstar SILVERLINE DELUXE, Руководство пользователя

Страница: 9 / 63

English
17
Recalling Patches
Press any Channel switch to load that patch.
Pressing the Bank switch will cycle through the three banks – green-orange-red.
The Channel will be preserved, therefore the corresponding patch within the current
Bank will be loaded when scrolling through the Banks.
Alternatively, patches can be recalled via Blackstar’s INSIDER software or any
connected footcontroller.
Factory Patches Table
Green Bank - Live Rig 1
Channel Patch Name Voice Response Effect(s) Description
CH1 LR1 - Clean Clean Warm 6L6 Spring Reverb US clean with high
headroom, perfect as a
platform for your pedals
CH2 LR1 - Crunch Crunch EL34 Hall Reverb British low gain crunch with
natural reverb
CH3 LR1- Rhythm Super Crunch EL34 Tape Delay, Hall
Reverb
British classic rock crunch,
ideal for guitars with
humbuckers
CH4 LR1 - Lead OD 1 KT88 Analogue Delay Full sounding dynamic lead
Orange Bank - Live Rig 2
Channel Patch Name Voice Response Effect(s) Description
CH1 LR2 - Clean Clean Warm 6V6 Plate Reverb US low wattage 'sag' clean
tone with natural reverb
CH2 LR2 - Crunch Clean Bright KT66 Hall Reverb Rhythm tone with breakup,
great for a classic Indie
sound
CH3 LR2- Rhythm OD 1 EL84 Hall Reverb Smooth drive with a slight
mid boost
CH4 LR2 - Lead Super Crunch 6L6 Analogue Delay,
Hall Reverb
Balanced lead tone with
delay, perfect for solos
Red Bank - Live Rig 3
Channel Patch Name Voice Response Effect(s) Description
CH1 LR3 - Clean Clean Bright KT88 Flanger,
Analogue Delay,
Hall Reverb
Modulated clean tone,
ideal for arppegiated
chords
CH2 LR3 - Crunch Crunch EL84 Plate Reverb Dynamic crunch, perfect
for big open chords
CH3 LR3- Rhythm Super Crunch 6V6 Analogue Delay,
Plate Reverb
Compressed crunch, great
for rhythm playing
CH4 LR3 - Lead OD 2 KT88 Analogue Delay,
Hall Reverb
Smooth high gain tone,
ideal for legato whilst
maintaining note definition
English
16
MIDI
Silverline Deluxe and Stereo Deluxe amplifiers are able to recall patches via MIDI
Program Change messages and to dynamically modify amplifier values via MIDI
Control Change messages.
To set-up MIDI control, simply connect your MIDI controller’s MIDI Out socket (30)
to the MIDI In socket on the rear of the amplifier.
From new, or after a Factory Reset, the amplifier is set to OMNI mode and responds
to MIDI messages on all MIDI channels.
NOTE: You may wish to set the amplifier to respond to MIDI messages on just a
single MIDI channel. This can be done using the Blackstar INSIDER software to
specify which of the 16 MIDI channels to use, or to return the amplifier to OMNI
mode.
Recalling Patches
To recall a patch, the MIDI controller should be set to transmit Program Change
messages (this is usually the case for footcontrollers). Changing patches on the MIDI
controller will activate the corresponding patch stored within the amplifier.
Modifying Patch Values
Many patch values (e.g. Gain, Volume, ISF – see MIDI Implementation Chart on
page 100) can be adjusted via MIDI Control Change messages in real-time. The
MIDI controller should be set to send the Control Change messages as defined in
the MIDI Implementation Chart.