Front Panel
1. Input
Plug your guitar in here. Always use a good quality screened guitar lead.
2. Voice
The Voice control changes the preamp voicing, ranging from ultra clean to extremely
overdriven.
Clean Warm – Classic clean, dynamic
Clean Bright – ‘Boutique’, will break up when pushed hard
Crunch – Classic medium gain overdrive
Super Crunch – More gain and punch than Crunch
OD 1 – Hot-rodded Master Volume overdrive
OD 2 – Mid boosted overdrive
This setting is saved when you store a patch.
3. Gain
The Gain control adjusts the amount of overdrive or distortion. Low settings, counter
clockwise, will deliver a clean sound on the edge of break-up. As the Gain control is
turned clockwise the sound will become more overdriven, moving through beautiful
crunch tones until, at its maximum position, a full distorted tone is achieved. This
setting is saved when you store a patch.
4. Volume
This controls the preamp volume. Turning it clockwise increases the volume.
High levels of volume will introduce the effect of valve power amp distortion and
compression, depending on the Response (9) setting you have selected. This setting
is saved when you store a patch.
5. Bass
The bass control adjusts the amount of low-end frequencies in your tone. This amp
has an advanced tone shaping circuit which allows the tone to be tight and cutting
(counter clockwise) to warm and thumping (clockwise). This setting is saved when
you store a patch.
6. Middle
The middle control adjusts the amount of middle frequencies in your tone. The
middle frequencies are particularly important in setting the amount of ‘body’
your tone has. With the middle control set to its minimum position (fully counter
clockwise) the sound will be aggressive and scooped, a tone ideal for aggressive
rhythm playing. As the middle control is increased (clockwise) the amount of ‘body’
is increased, which is more suitable for sustained lead guitar tones. This setting is
saved when you store a patch.
English
9
English
8
Factory Reset
The default factory patches and settings can be restored to your amplifier at any
time. Simply hold down the MOD, DLY and REV switches simultaneously, whilst
switching on the amplifier. The bank LED will illuminate, and change from green, to
orange, to red, to indicate that a factory reset is imminent. This process will take a
total of two seconds. If any of the MOD, DLY and REV switches are released before
the bank LED has cycled through all colours and switched off, then the operation is
cancelled and the amplifier will remain unaffected.
IMPORTANT NOTE:
This process will overwrite any user content.
