IMPORTANT INSTRUCTIONS FOR SET UP.
Important instructions for setting up the device! You must read these before
1
st
use!
1.
Adjust the distance between the blade and axel blade. The
correct distance is
approx. 2 mm +/- 0.5 mm. Check if the distance between the blade and the axel
blade is consistent for both rotor blades by turning them manually.
2.
Check that all of the screw joints on the device are secure; this applies especially
to the bolts for both blades and the axel blades. Tighten all of the screws. Repeat
this process after the first operational hour after setup!
Attention: the bolts for all blades are secured with Loctite screw lock! If you
want to loosen the bolts (e.g. for changing the blades) please heat up the bolts
first, otherwise they will shear. When again fastening the bolts also please use
a bit of Loctite screw lock.
3.
Check that the driving belt and belt pulley are aligned and straight. If they are
slanted, this can be repaired by adjusting the engine. Both belts should be
tightened. The belts should sag a maximum of 10 mm in the centre at the correct
tension level.
