1.
GENERAL
Intended use
The shredder is designed solely for shredding/chipping all
kind of newly cut tree branches of diameter up to 8.5 cm.
Restrictions
You should not use the shredder for shredding/chipping metal, stones, and
plastics. If you are going to shred tree roots check that the diameter is less
than 8.5 cm and remove all earth, sand stones.
Before using the machine for the first time, check the maximum engine speed
by screwing in/out the screw which controls the position of the throttle lever
so that it is positioned as in the diagram. (fig.3) after the first hour’s use check
that the bolts of the blades and counter blade are firmly fixed and that the gap
between blades and counter blade is 0.5mm (half a millimetre). Adjust in the
slots necessary and fix the bolts. (fig.2a,ab)
Description of the machine
The shredder is a machine for shredding/chipping newly cut wood. The rotor
has 2 blades each with a 30 cm width and is powered by a gasoline engine.
Transmission is through two parallel drive belts. The shredded wood or chips
are discharged through the output tube by the centrifugal force of the rotor.
Because of the angle of the blades and the positioning of the counter blade
branches are pulled inside the machine automatically and feeder belt is
required. (fig.1)
8.5
cm
