7
TONADO- Item code: BH17.
Instruction Manual
JOINING THE WING HALVES.
1. Locate the aluminium wing dihedral
brace.
2. Using a modeling knife, remove the
covering wing.
3. Test fit the dihedral brace into each wing
half. The brace should slide in easily. If not,
use 220 grit sandpaper with a sanding block
and sand down the edges and ends of the
brace until it fits properly.
Top side.
C/A glue
Remove covering.
Mark point.
Top side.
INSTALLING THE STOPPER ASSEMBLY
1. The stopper has been pre-assembled at
the factory.
2. Using a modeling knife, cut one length of
silicon fuel line (the length of silicon fuel line is
calculated by how the weighted clunk should
rest about 8mm away from the rear of the tank
and move freely inside the tank). Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the
stopper.
3. Carefully bend the second nylon tube up
at a 45 degree angle (using a cigarette lighter).
This tube will be the vent tube to the muffler.
4. Carefully bend the third nylon tube down
at a 45 degree angle (using a cigarette lighter).
This tube will be vent tube to the fueling valve.
Aluminium brace.
Epoxy glue.
FUEL TANK.
