15
TONADO- Item code: BH17.
Instruction Manual
6. After the epoxy has fully cured, re-
move
the masking tape or T-pins used to hold the
stabilizer in place and carefully inspect the
glue joints. Use more epoxy to fill in any
gaps that were not filled previously and
clean up the excess using a paper towel and
rubbing alcohol.
5. When you are sure that everything is
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
top and bottom of the stabilizer mounting area
and to the stabilizer mounting platform sides
in the fuselage. Slide the stabilizer in place and
re-align. Double check all of your
measurements one more time before the
epoxy cures. Remove any excess epoxy using
a paper towel and rubbing alcohol and hold
the stabilizer in place with T-pins or masking
tape.
Epoxy glue.
C/A glue.
Elevator control horn install as same as the
way of aileron control horn. Please see pictures
below.
Control horn of elevator.
3mm x 40mm.
M3 lock nut
.
Nilon
control clasp.
Remove
covering.
ELEVATOR CONTROL HORN INSTALLA-
TION.
Drill 1 hole with 6 mm diameter.
Mark point
