19
TONADO- Item code: BH17.
Instruction Manual
6) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the vertical
stabilizer mounting area. Apply epoxy to the
lower rudder hinge. Set the stabilizer in place
5. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 degree
to the horizontal stabilizer.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
and re-align. Double check all of your meas-
urements once more before the epoxy cures.
Remove any excess epoxy using a paper
towel and rubbing alcohol and hold the stabi-
lizer in place with T-pins or masking tape. Al-
low the epoxy to fully cure before proceeding.
Epoxy glue.
C/A glue
Rudder control horn install as same as the
way of aileron control horn. Please see pictures
below.
CONTROL HORN OF RUDDER.
Epoxy glue.
3mm x 40mm.
M3 lock nut
.
Nilon
control clasp.
RUDDER CONTROL HORN INSTALLATION.
