TONADO- Item code: BH17.
Instruction Manual
18
2. Slide the rudder into the fuselage as
same as picture below.
Remove
covering.
Hinge slot.
1) Using a modeling knife, remove the
covering from the top of the fuselage and the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage This
slot accepts the lower vertical.
3. Mark the shape of the vertical on the left
and right side on the rudder using a felt-tip
pen.
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rudder.
Just as you did with the horizontal stabilizer,
make sure you only press hard enough to cut
the film, not the balsa rudder.
C/A glue.
C/A glue.
C/A glue.
C/A glue.
Pen.
