5
HAWKER HURRICANE Item code: BH147
.
Instruction Manual
3)
Using the thread as a guide and using mask-
ing tape, tape the servo lead to the end of the thread:
carefully pull the thread out. When you have pulled the
servo lead out, remove the masking tape and the servo
lead from the thread.
Drill a hole
1.5mm
Servo tray
Remove the covering
Secure
Electric wire
4)
Place the servo into the servo tray. Center
the servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four mount-
ing screws provided with the servo.
Electric wire
Drill a hole
1.5mm
2x10mm
Secure
5)
Repeat the procedure to install the aileron
servos in the opposite wing half
.
3. INSTALLING THE AILERON CONTROL HORN
1)
Remove the covering from the slot on the
bottom of the aileron.
2)
Insert the control horn into the slot and secure
it by A+B Epoxy glue.
1. A+B Epoxy glue
2. Push in
Aileron
control horn
4. INSTALLING THE AILERON LINKAGES
3)
Repeat the procedure to install the control
horn on the opposite aileron.
Installing the aileron linkages as pictures below.
100mm
Snap keeper.
