14
HAWKER HURRICANE Item code: BH147
.
Instruction Manual
Repeat the procedure for the other wing half.
XV. INSTALLING COCKPIT
FUSELAGE
Locate the aluminium wing dihedral brace.
XIV. WING ATTACHMENT
*** Test fit the aluminium tube dihedral brace into each
wing haft. The brace should slide in easily. If not, use
220 grit sand around the edges and ends of the brace
until it fits properly.
Attach the aluminium tube into the fuselage.
500mm
Aluminium tube.
19mm.
Insert the wing panel as pictures below.
Screw the wing panel in position.
Push in
Push in
Push in
Pillot
A/B Epoxy glue.
Secure
XIII. INSTALLING THE SWITCH,
RECEIVER AND BATTERY
1)
Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two mounting holes
through the fuselage side.
2)
Secure the switch in place using the two machine
screws provided with the radio system.
3)
Plug the servo leads and the switch lead into
the receiver. You may want to plug an aileron extension
into the receiver to make plugging in the aileron servo
lead easier when you are installing the wing. Plug the
battery pack lead into the switch.
4)
Wrap the receiver and battery pack in the protec-
tive foam to protect them from vibration. Use a rubber
band or masking tape to hold the foam in place.
5)
Position the battery pack and receiver behind
the fuel tank. Use two tie wraps to hold the battery and
receiver securely in place as pictures below.
Do not permanently secure the receiver and battery
until after balancing the model.
6)
Using a 2mm drill bit, drill a hole through the side
of the fuselage, near the receiver, for the antenna to exit.
Receiver
Battery
Switch
