TWISTER.
INSTRUCTION MANUAL
17
1) Using a modeling knife cut away the
covering from the fuselage for the rudder and
remove it.
VERTICAL INSTALLATION
2) Slide the rudder into the fuselage as
same as picture below.
3) Mark the shape of the vertical on the left
and right side on the rudder using a felt-tip
pen.
4) Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rudder.
Just as you did with the horizontal stabilizer,
make sure you only press hard enough to cut
the film, not the balsa rudder.
5) Put the vertical stabilizer back in place.
Using a triangle, check to ensure that the
vertical stabilizer is aligned 90 degree to the
horizontal stabilizer.
Remove covering
Mark point
Rudder servo
Remove covering
