TWISTER.
INSTRUCTION MANUAL
15
6) After the epoxy has fully cured, re-
move
the masking tape or T-pins used to hold the
stabilizer in place and carefully inspect the
glue joints. Use more epoxy to fill in any
gaps that were not filled previously and
clean up the excess using a paper towel and
rubbing alcohol.
C/A glue
Elevator control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Control horn of elevator.
C/A glue
3mm x 40mm.
M3 lock nut
.
Nilon
control clasp.
ELEVATOR CONTROL HORN INSTALLA-
TION.
Mark point
Drill a hole with 6mm (diameter)
Remove covering
