TWISTER.
INSTRUCTION MANUAL
7
4. Locate one nylon servo arm, and using
wire cutters,remove all but one of the arms.
Using a 2mm drill bit, enlarge the third hole
out from the center of the arm to accommodate
the aileron pushrod wire.
5. Using pliers, carefully make a 90
degree bend down at the mark made. Cut off
the excess wire, leaving about 4mm beyond
the bend.
6. Insert the 90 degree bend down through
the hole in the servo arm. Install one nylon
snap keeper over the wire to secure it to the
arm. Install the servo arm retaining screw and
remove the masking tape from the aileron.
JOINING THE WING HALVES
1.
Locate the aluminium wing dihedral
brace. Using a ruler, locate its centre and
draw a vertical line .
Remove covering
Bend and cut after
3.
Test fit the dihedral brace into each
wing half. The brace should slide in easily up
to the centreline that you drew. If not, use 220
grit sandpaper with a sanding block and sand
down the edges and ends of the brace until it
fits properly.
2. Using a modeling knife, remove the cov-
ering wing.
