50
SERVSWITCH WIZARD PRO
Appendix B: Rackmounting the
ServSwitch Wizard Pro
If you want to mount your ServSwitch Wizard Pro in a 19" rack, you’ll need our
ServSwitch Wizard Pro Rackmounting Kit (product code RMK19WP). Each of
these Kits consists of two rackmounting brackets and four screws. To use a Kit to
mount a ServSwitch Wizard Pro, take these steps:
1. Refer to Figure B-1 below to determine how you want to mount the Switch. If
your rack is deep enough, we recommend the normal installation shown on
the left, which allows the front of the Switch to be flush with the front of the
rack. If your rack is too shallow for that, however, you can reverse the brackets
and install the Switch so that it protrudes from the front of the rack, as shown
on the right.
2. Match up the two holes in the “Switch end” of each Kit bracket with the two
empty screwholes on the side of the Switch, then fasten the bracket to the
Switch with two of the screws included with the Kit.
3. Once you’ve attached both brackets, match the holes in the “rack end” of
each bracket to an appropriate set of matching holes on your equipment
rack, then screw the Switch assembly to the rack using your own screws, bolts,
or cage nuts (not included).
Figure B-1. Rackmount assembly, standard (left) or shallow (right).
