Black Box RAS-PutIn, Инструкция по установке и эксплуатации

Страница: 26 / 93

14 CHAPTER 3. INSTALLATION
RAS-PutIn. By the date of printing this manual supported options are:
ˆ
Avocent
—
SPC
1
800/1600
ˆ
Sentry In-Line Power Module
ˆ
Leuning ePowerSwitch
3.3.5 Connecting Ethernet
The rear side of RAS-PutIn provides a RJ-45 connector for Ethernet. The connector is used
either for a 100 Mbps 100BASE-TX connection or for a 10 Mbps 10BASE-T connection. The
adapter can sense the connection speed and will adjust to the appropriate operation mode
automatically.
3.3.5.1 10 Mbps Connection
For 10BASE-T Ethernet networks, the Fast Ethernet adapter uses Category 3, 4, or 5 UTP
cable. To establish a 10 Mbps connection, the cable must be connected to a 10BASE-T hub.
1. Make sure that the cable is wired appropriately for a standard 10BASE-T adapter.
2. Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the
adapter’s connector.
3.3.5.2 100 Mbps Connection
For 100BASE-TX Fast Ethernet networks, RAS-PutIn supports Category 5 UTP cabling. To
establish a 100 Mbps connection, the cable must be connected to a 100BASE-TX hub.
1. Make sure that the cable is wired appropriately for a standard 100BASE-TX adapter.
2. Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the
adapter’s connector.
Note:
The UTP wire pairs and configuration for 100BASE-TX cable are identical to those for
10BASE-T cable when used with Category 5 UTP cable.
3.3.6 Connecting ISDN
The rear side of RAS-PutIn contains two RJ-45 connectors. The upper connector, marked as
’ISDN’ is used to connect RAS-PutIn to an ISDN network, using a standard ISDN cable.
1
Avocent is a registered trademark of Acovent Corp. Huntsville