CHAPTER 3: Installation
17
2. With the Concentrator’s faceplate (the front of the unit) towards you, take the Rackmount Kit’s brackets
and place one on either side of the Concentrator, so that the front end of each bracket lines up with the
faceplate.
3. There are slots in each side of the Concentrator that are made to accept the brackets’ rear flanges, as
shown below. Swing the front of each bracket outward, insert the flanges in these slots, and swing the front
back in. (If, after you do this, the front of a bracket doesn’t line up with the Concentrator’s faceplate, or
the screwholes along the top of the side a bracket don’t line up with the screwholes on the side of the
Concentrator’s chassis, swing the bracket back out and adjust how the flanges are seated in the slots.)
4. Using the four included
6
⁄
32
x
1
⁄
4
-inch flathead screws, attach each bracket to the Concentrator along the top
of the Concentrator’s chassis, as shown below.
Front panel of Concentrator
Bracket screw holes
Insert flanges...
...then swing inward
Bracket
Bracket
Screws
Screws
