10
7
8
9
7 SECURING VALVE BODIES
From above fi xture, hold the Flat Shaped Flange (
7A
) and turn the Valve Body
(
7B
) by hand in a clockwise direction until the assembly is snug. Tighten the
Valve Body using an adjustable wrench, 1 turn maximum. If a lever or cross
handle is used, rotateValve Body for desired handle alignment.
(Do not over
tighten)
.
8 VALVE BODY INSTALLATION INTO SMALL SINK HOLE
If the fi xture hole is too small for valve assembly, remove Retainer Nut (
8A
) by
holding the Flange (
8B
) in place and turning valve body counter-clockwise until
Retainer Nut is free of valve body. Insert body, from above fi xture, through fi xture
hole. Thread on Retainer Nut (
8A
) from below fi xture. Make sure the Ears (
8C
)
slide through the Slots (8E) in the Retainer Nut (
8A
) and that the fl at side of the
Retainer Nut is facing up. Be sure Dimples (
8D
) on the nut are facing down.
9 HOSE CONNECTION TO SPOUT
From underneath sink, push the Center Connector (
9A
99
) onto Receiving Tube
(
9B
), until unable to push any further. Pull down on the Quick Connect Housing
(
9A
99
). If the housing and the Inner Collet (
9C
) separate slightly but do not pull
off the Receiving Tube (
9B
), the connection is secure.
10 HOSE CONNECTION TO VALVE BODY
Slide the End Conectors (
10A
) onto the Valve Bodies (
10B
). Push the End
Connectors (
10A
) all the way up until completely seated. Be careful not to
damage O-Rings (
10C
).
3
ENGLISH
7B
7A
7A
7B
7B
8A
8B
8C
9A
9B
9B
9A
9A
9B
9C
9A
10C
10C
10B
10A
10A
10B
7B
8D
8A
8E
