To Reinstall Blade
a.
Slide the blade sideways into the holder until it is against
the end stop. Blade groove must be toward back of unit.
b.
Securely tighten the three nuts using the wrench supplied.
c.
Rotate the blade drum 180˚ degrees and repeat for other
blade.
d.
Always replace both blades.
PARKING FOOT (Fig. L)
Your planer is equipped with a parking foot
(15)
that
automatically lowers into place when the tool is lifted from the
work surface. When planing, the parking foot raises as the tool
is pushed forward. When the parking foot is lowered, the
planer can set on the work surface without the blade touching.
Caution
!
Do not lock the trigger switch on and engage the
parking foot. The vibration of the running motor will cause the
planer to move, possibly falling from the work piece.
EDGE CHAMFERING (Fig. M)
Your planer has three precision machined chamfering grooves
1.5mm, 2.0mm and 2.5mm
(16).
They are located in the front
shoe and are used for planing along a corner of the material
(Fig. M).
a.
Adjust to desired depth of cut.
b.
Place groove
(16)
over edge of material.
c.
Apply weight to front of shoe so groove is flat on material
edge.
d.
Hold tool with both hands keeping pressure on front handle.
Note:
It
ʼ
s a good idea to try a piece of scrap wood
before doing finish work.
DRIVE BELT (Fig. N)
Warning
!
Turn off and unplug the tool before making any
adjustments or removing or installing accessories.
To Replace Belt
a.
Loosen the three screws shown in
Fig. N
and remove the
belt cover.
b.
Remove old belt.
c.
Place new belt over front pulley then rotate belt clockwise
while pushing belt onto back pulley.
d.
Attach belt cover and securely tighten screws.
MAINTENANCE
Your tool has been designed to operate over a long period
of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
Warning!
Before performing any maintenance, switch off
and unplug the tool.
Cleaning
► Turn off and unplug unit before cleaning chip discharge
chute. Clean the chip discharge chute
(6)
regularly.
Always wear safety glasses.
► Never use solvents or other harsh chemicals for cleaning
the non-metallic parts of the tool. Use only mild soap and
damp cloth to clean the tool. Never let any liquid get
inside the tool; never immerse any part of the tool into
a liquid.
SERVICE INFORMATION
Black & Decker offers a full network of company-owned
and authorized service locations. All Black & Decker Service
Centers are staffed with trained personnel to provide customers
with efficient and reliable power tool service. For more
information about our authorized service centers and if you
need technical advice, repair, or genuine factory replacement
parts, contact the Black & Decker location nearest you,
or visit us at
www.BlackandDecker-la.com
SPECIFICATIONS
CE750
Power
750W
Speed
n
0
16500/min
Max. depth of cut
2,0mm (5/64")
Rabbeting capacity
12mm (15/32")
Shoe length
29cm (11-½")
Planing width
82,5mm (3-¼")
3 Chamfer grooves
1,5/2,0/2,5 mm
Cord
2m
ENGLISH • 21
