55
the Slaves before the Master. Follow the steps below to set a supply to
master or slave mode (Note: Multi-unit connection (chain) mode will be
cancelled).
1.
Press the
button and press the
button one time until
CONFIG is blinking and press
.
2.
Press
button four times until PARALLEL is blinking and
press
.
3.
Press
to select the parallel MODE.
4.
Use the rotary knob to select the setting of OFF or ON and press
.
5.
Press
button one time until ROLE is blinking and press
.
6.
Use the rotary knob to set the master or slave and press
.
Use the same procedure to set up MASTER, SLAVE 1, SLAVE
2,…,SLAVE 49 for the other power supplies.
7.
Press
several times to exit the menu setting.
Slave Unit
When a power supply is set up to be a slave unit, it will wait for the
master’s connection, as shown below.
If the master unit has found the slave unit, the slave unit will be
controlled by the master unit and the following will be displayed:
