Magicians SOCD Cleaner V2
Section 6: Electrical
INSTALLATION MANUAL & USER GUIDE
REV B
PAGE 9
Pinouts & Descriptions
The Magicians SOCD Cleaner V2 is simple to put together if you have done a similar type of
mod. If this is your first time putting something like this together, we highly suggest reading
this entire section to get acquainted with all the connections.
Power Input Screw Terminal Block
The main way to connect power. Wire up +5V and ground and you are all set. On after-market
controller boards such as a Brook board, you can tap power off its screw terminal block. If it is
an OEM control board, you will need to tap into the USB power lines. The power input here is
protected from reverse polarity.
Pin #
Name
Typical Color
1
V+
RED
2
GROUND
BLACK
Connection Type:
Screw Terminal, 18-30AWG wire
Connector Map Number:
1
Pass-thru Harness Port
Where to connect a pass-thru harness so that it is not necessary to modify your controller’s
power wiring. Vendors such as
Connection Type:
JST ZH
Connector Map Number:
2
If your control board does not offer an easy way to tap power
or you are not able to get a pass-thru harness, you will need to
either t-tap (these are included along with some wiring with
sample demo
) or manually tap (requires wire strippers or
knife, and a steady hand with some electrical tape). This may
be difficult for you to do if you are not comfortable with
electrical wiring mods.
Pin 1
Pin 2
