Bison MMIB-20, Руководство оператора

Страница: 30 / 72

Once all the necessary adjustments have been
made according to the Operator’s Manual, the
operation of the mill can be started as follows:
1. Place the sacks in each of the outputs of the
bagger. Turn the handles (A) to hold the sack. Orient
the baffle so that the sack you want gets filled first.
2. Turn on the tractor, accelerating with the lever
(1) or pedal (2) slowly until it reaches 540 RPM to
PTO output. With this we achieve that the contact
between the different pieces of traction (arrow shaft,
motor pulley arrow, driven pulley arrow, bolts and
hammers) is carried out in a smooth way. Otherwise,
it can damage the Mill in general.
3. When the tractor moves to the next pile of material
to be ground and has to turn because it encountered
an obstacle (rock, tree, vehicle, etc.), do not perform
the operation (turn) abruptly as it may twist the
arrow shaft or damage the bearings.
You must make the turns in such a way that this
problem is avoided. It would be advisable to
uncouple the arrow shaft to avoid damaging it.
If you operate the Mill in stationary form (without
tractor feed) you will not have the above problem,
unless the Mill and the tractor are not aligned.
NOTE:
If you operate a MMIB20 Mill: Verify that the
chassis legs are supported firmly on the ground on
which it is going to work. If it’s necessary to move, lift
the mill enough with the hydraulic system so that the
legs do not make contact with stones, shrubbery,
terrain irregularities, plant waste, etc. with which it
may come across on the way.
IMPORTANT:
Do not move the mill with the chassis
resting on the ground; this would cause damage to
the structure.
CAUTION:
If it’s necessary to move the Mill, unplug
the PTO and to take closed turns with the MMRB-
20 Mill, disconnect the arrow shaft in order to avoid
damaging it.
OPERATION
25
A
B