Bison MMIB-20, Руководство оператора

Страница: 29 / 72

TIRES PRESSURE
Only for Mill MMRB20
IMPORTANT: Both tires must have the same air
pressure.
Proper inflation is essential for a long tire life. The lack of air pressure
allows the tire to slip on the rim and the side walls to deform, resulting
in broken stems and uneven wear of the tread. Too much pressure
undue effort produced in the structure of the tire and may result in
breakage due to impact with stones, roots or logs. It also causes
excessive wear of the tread and allows tires to bury more in wet
terrain.
Keep the valve plugs tightened on the valve stems. This will prevent
dust, gravel, mud and other foreign matter from entering to the core of
the valve, allowing the compressed air to escape.
Frequently check the tire pressure with a pressure gauge (A) and
inflate or deflate them for correct air pressure as it is given in the
following table:
GRADE PRESSURE
175/70R13 kpa (240)
psi (32)
ATTENTION: Tires can lose one pound per square inch
of pressure (1psi) per month under normal conditions, and by
every 6 degree Celsius that the temperature falls.
DANGER: If the screen breaks, some fragment that comes off
can be ejected and can result in death or serious injury.
SCREENS SELECTION
IMPORTANT: Replace the screens before they break,
as any fragment that comes off could damage the Mill
in general
.
Wear gloves whenever you change the screens.
Depending on what you want to grind (grains or forage), you will use
screens with holes of different diameter.
Below is a table of the screens and their use:
HOLES
SPECIFICATIONS
USAGE
12 mm diameter
6 mm diameter
Dry Forage
Grains
If you need an specific hole diameter in screens, for grinding a
particular grain, check pages 53 and 54 or consult your authorized
dealer.
ATTENTION: Each screen has its own usage. If you do not
apply this principle you will get bad results when grinding.
OPERATION
A
24