5
10
Switching device INT-50, 51
11x Bolt M6 x12
2 x Nut M6
Coil INT-FIX 50
1
System Components
1
1
2
3
3
4
4
Floor bracket INT-MC 50
2 x Plastic sleeve
Converter INT-MOB 50
Hollow pin
5
6
6
7
8
2 x Mounting bracket INT-MS 50
16 m steel cable
Compression spring
2 x Bolt M4 x10
9
10
12
11
13
12
2 xNut/
Washer for M8
Banjo bolt
13 x Washer for M6
2 x Cable lug for M6
13
17
14
15
16
Prior to starting installation or fault rectification, take the
following safety precautions:
• Disconnect the system from the power supply
• Secure the system against unintentional restarting
• Make sure that the system is not live!
• Ground the phases and short-circuit them
• Cover any neighbouring live parts or remove them
• Cover the unit during mounting! Foreign bodies (e.g. drillings) can damage the devices
• If there is a high risk of contamination or if the ambient atmosphere is aggressive,
protect the device with a housing
Safety Instructions
• Mounting, startup, modification and retrofitting of the system may only be carried out by
an electrician!
• Before starting work, disconnect the unit / system from the power supply!
• While electrical switching units are being operated
– individual parts carry dangerous voltages,
– dangerous, ionised gases can escape, e.g. if a short-circuit occurs,
– protective covers may not be removed
• Observe the safety regulations of electrical engineering and theTrade Association!
• If safety regulations are not observed, this can lead to death, serious injury or considerable
material damage!
• Keep these operating instructions for later use!
Fig.
1
2
10
14
7
8
11
9
15
17
16
