OPERATION AND CONNECTION METHOD OF OZONE GENERATOR WITHOUT AIR DRYING
AND OXYGEN APPARATUS
●
Operation and connection method of ozone generator without air-drying or oxygen apparatus are
shown in Fig.9. Connect air outlet 7 directly to oxygen inlet 9.
●
Ozone generator without air-drying or oxygen apparatus: does not increase system cost and it is
suitable for application with low demand of ozone production since the ozone production is unstable
and is affected by the environment humidity and purity, normally it is advised to use in a clean
environment with an air conditioner.
OPERATION AND CONNECTION METHOD OF OZONE GENERATOR WITH AIR-DRYING OR
OXYGEN APPARATUS
Special reminder: drying tank, drier, oxygen generator, oxygen bottle and other parts, which mentioned below
are not included in the standard ozone generator and will need to be purchased separately.
●
To ensure stable yield of ozone generators, dry and clean air or oxygen is required to the ozone
generator. Using untreated compressed air, which contains large amounts of water, oil and dust, will
affect the yield and service life of ozone generators. Generally air-dying or oxygen apparatus are
equipped with an ozone generator.
Methods of using air-drying facilities or oxygen apparatus
●
Equip silica gel drying tank (Special reminder: Silica gel dryer, indicated in the figure, can also be
replaced by other dryers; the drying tank needs to be purchased separately.)
●
Connection of silica gel drying tank
●
Condition permitting, silica gel drying tank should be suspended as shown in fig.10; if not, it should
be installed on the ozone generator (¼ joint with screw nut should be replaced by ¼ two-end male
straight joint
●
Proper inlet and outlet connection of silica gel drying tank; air flow direction is as the blue arrow
indicates. (don't subject to the direction of the original “out” and “In” on the tank.)
●
Replace silica gel in the tank when it is saturated and turns red to blue.
Advantage and shortcoming of using silica gel drying tanks: most economical, but silica gel has to be
often dried and replaced.
Ozone generator with inner heating-drying tank
●
Structure and operating instruction of the product with inner drying tank are indicated in chapter 8 of
this manual.
●
While using drying machine to supply dry and clean air to the ozone generator, connect dry and
clean air from drying machine to oxygen inlet 9 (fig.4) Leave air outlet 7 of the ozone generator in
this manual (fig.4) un-connected and air pump switch 2 (fig.4) off.
●
While using a drying machine to supply dry and clean air to ozone generators, SOZ-YOB-G
integrated oxygen / air ozone generators from our company can be a good substitution.
Advantage and shortcoming of using a drying machine: convenient operation, but the cost is higher
than equipping silica gel drying tank and inner heating-drying tube.
12
