Page 8
Document# 430-00146-01
© Copyright 2003 - 2005, Bioscrypt Inc. All rights reserved.
Figure 1: Outdoor Enclosure Rear Mounting Schematic
Assembling the Roxtec Gland M63 Enclosure Seal
Before installing the Roxtec Gland M63 enclosure seal, you will need to first remove
the Sub Panel from the Outdoor Enclosure by unscrewing it from the four metal posts.
The four metal posts should remain connected to the enclosure to hold the optional
heater in place. Once this is complete, please follow the steps below to install the
seal into the enclosure. Please refer to the Assembly Instruction Roxtec Gland M63
sheet provided with the seal for visual representations of the steps outlined below.
Separate the lock nut from the gland housing.
Check that the O-ring is in the right place.
Through the rear, insert the gland housing in the Outdoor Enclosure access hole
so that the gland housing protrudes past the Outdoor Enclosure.
Within the Outdoor Enclosure, fasten gland housing with the lock nut.
Pull all the required cables through the gland housing and into the Outdoor
Enclosure.* Please refer to the Veri-Series Setup Guide and Veri-Series
