Page 12
Document# 430-00146-01
© Copyright 2003 - 2005, Bioscrypt Inc. All rights reserved.
It is best to mount the Outdoor Enclosure to the wall before the Veri-Series Fingerprint
reader is mounted within the enclosure.
The Outdoor Enclosure shall be designed to mount directly to any solid surface
including a wall anchor, wood, sheet metal, or dry wall. When mounting on drywall,
please ensure that at least one vertical pair of mounting holes is secured to a stud.
Using 4 screws with a thread type no larger than 5/16”, mount the Outdoor Enclosure
to the wall so that the Roxtec Gland M63 seal fits into the access hole that was
created earlier in the wall. Please refer to Figure 1 which displays the rear-mounting
surface of the enclosure and its dimensions.
Finally, if installing an Outdoor Enclosure that includes the optional bonded window,
please remove the protective film from the bonded window at this time.
Mounting the Veri-Series Fingerprint Reader
Follow the steps listed below to mount the Veri-Series fingerprint reader to the
Outdoor Enclosure:
Attach the 15-Conductor Pigtail, Weidmuller Connectors, RJ45 and/or RJ11
cables to the Veri-Series fingerprint reader body (or fingerprint verification
module on the V-Smart).
For the V-Smart reader, additionally connect the Molex connection to the
smart card interface module.
Slide the Veri-Series fingerprint reader body into the Veri-Series Wall Mount using
the tabs located on the rear of the reader.
Secure the Veri-Series fingerprint reader body to the Veri-Series Wall Mount
using the #4-40 inch screw(s) provided with the reader.
Snap the RJ11 security cover into place:
o
With the textured side facing down, place the left tab into the left corner
groove on the reader body.
o
Rotate the cover until the right tab easily slides into the groove.
o
With the tab in the reader body groove, rotate the cover clockwise until
the right tab snaps into place at the right rear corner.
o
Fold the cover up and secure it using the supplied pin-in-hex security
screw and Allen wrench.
The Veri-Series fingerprint reader is now ready for use outdoors. When a user needs to
access the reader, simply lift the front lid and initialize the verification. Once the
verification is complete the lid may be closed once more. The Outdoor Enclosure
