Bionizer Eco - Oxidizer, Инструкция

Страница: 11 / 16

BEFORE OPERATING THE ECO-OXIDIZER :
1. Balance the Pool according to the Pool Balance
information below. This is also shown on the Snap
Pool Balance chart supplied with the Eco-Oxidizer.
Feel free to take that chart to your pool shop if you
prefer them to test your water.
2. It is not advised to use skimmer basket type
clarifying cubes that treat Total Dissolved Solids
(TDS) and Phosphates when operating the Eco-
Oxidizer.
3. Operate the Eco-Oxidizer on a low setting initially
(as per Suggested Output Settings on page 8). The
unit will condition the pool water correctly during
the next 3 to 7 days under normal filtering times of
4 to 8 hours per day, depending on pool size.
4. Backwash your filter if it is a sand filter, or wash
your filter if it is a cartridge type filter. Refer to your
filter’s handbook.
INITIAL START-UP OPERATION
PLEASE READ THIS IMPORTANT INFORMATION BEFORE OPERATING YOUR ECO-OXIDIZER.
NORMAL OPERATION
1. Set the Oxidizing Output level to Off 2 to 3 hours
before adding any phosphate removers,
flocculants, clarifiers or waterline scum detergents
or the like. (See Suggested Output Settings, page
8).
2. Leave the Eco-Oxidizer output setting in the Off
position for 72 hours after adding any of the
products listed above.
3. If the pool water becomes cloudy at any time we
suggest testing the various pool balance levels and
re-balancing the pool water according to the Pool
Balance information below. This is also shown on
the Snap Pool Balance chart supplied with the Eco-
Oxidizer. Feel free to take that chart to your pool
shop if you prefer them to test your water.
4. Check the pressure gauge attached to your filter
regularly. If the pressure is more than 50kPa above
the clean running pressure, then the filter must be
cleaned. Sand filters must be backwashed, and
cartridge filters must be disassembled, washed
with water, and reassembled. Refer to your filter’s
handbook.
5. To depend on the Eco-Oxidizer to remove the
cloudiness and restore clarity before testing the
water balance levels is asking the Oxidizing unit to
fix a problem that only has one solution. Correct
water balance and efficient filtering with a clean
filter will restore clarity…if this does not clarify the
pool water then it is most likely requiring more
oxidation.
To put it more simply… if the filter is operating
normally, with no heavy bather load upsetting the
water clarity, then any cloudy or hazy appearance
in the water is most likely due to the pool water
being unbalanced.
OPERATION
11