Bionizer Eco - Oxidizer, Инструкция

Страница: 7 / 16

SAFETY AND INSTALLATION
SAFETY INSTRUCTIONS - READ
IMPORTANT :
It is important to follow basic safety precautions
when installing and using this electrical equipment,
including the following :
1. Ensure you read and follow all instructions.
2. WARNING - Do not allow children to use this
product unless they are closely supervised at all
times. This is to prevent accidental injury.
3. Keep all cables visible and do not bury them.
Also, position them so that they do not get
damaged by lawn mowers, hedge trimmers and
other equipment.
4. WARNING - To prevent electrical shock, replace
damaged cords immediately.
5. Read these instructions and keep the instruction
manual in a safe place.
CAUTION :
Your warranty could become invalid should you fail
to observe the following :
1. The Eco-Oxidizer must be installed and operated
as specified.
2. The life of the unit will be extended (as with most
other pool equipment) if it is placed indoors or in
an enclosed structure.
3. Always power the Eco-Oxidizer from a genuine
Bionizer power adaptor. An incorrect adaptor
could damage the Eco-Oxidizer and will void your
warranty.
CONTROL BOX INSTALLATION
1. Choose a position that will allow you to see the
Eco-Oxidizer LED readout easily. Fix the control
box in position using screws at each corner of the
box. Ensure that the Eco-Oxidizer is positioned
near enough to a power outlet and to the
Oxidizing Pod so the cables reach without
straining.
2. Make sure that the unit is undercover to avoid
UV damage from long term exposure to sunlight.
3. Plug the power adaptor into a suitable power
outlet. The Eco-Oxidizer should only be powered
on when the pool pump is running. This can be
done in several ways :
1) For new version Bionizer with 12V DC
outputs sockets, use the adaptor cable to
connect the Eco-Oxidizer to the Bionizer.
2) For earlier Bionizer or other systems with a
pool pump power outlet, plug the power
adaptor into the outlet provided. Use a
double adaptor if necessary.
3) Use a separate timer switch, which has been
tuned to the same times as the timer
controlling the pool pump.
5. Connect the low voltage plug to the Eco-Oxidizer
DC Power Socket (see Page 5). Use only a
genuine Bionizer power adaptor. An incorrect
adaptor could damage your Eco-Oxidizer and
void your warranty.
DO NOT SWITCH THE POWER ON UNTIL
INSTALLATION HAS BEEN COMPLETED.
The Eco-Oxidizer can be installed onto a new pool or
an existing pool with minimal pool preparation.
Ensure that the pool is clean and correctly balanced.
See Initial Operation section on page 9.
1. Installing your Eco-Oxidizer takes around 30
minutes.
2. Alternatively engage a competent person to do
the job.
3. If installing it yourself you will need :
! PVC pressure glue and primer.
! A fine tooth saw.
! Philips Screwdriver
! For masonry walls : hammer drill with 6mm or
1/4" masonry bit.
!
Sandpaper or small file.
ECO-OXIDIZER INSTALLATION
7