Bionizer Eco - Oxidizer, Инструкция

Страница: 12 / 16

MAINTENANCE
A LITTLE MAINTENANCE WILL HELP YOU GET THE MOST FROM YOUR ECO-OXIDIZER
The Eco-Oxidizer features a self-cleaning system for
the electrodes. However, periodic cleaning in acid
may still be required, especially when used in marble
sheen pools with higher calcium hardness levels than
usual.
Cleaning is recommended every 12 months, or
earlier if excessive white calcium build-up can be
seen on the electrode surfaces.
If the LEDs on the Eco-Oxidizer’s front panel are
flashing, this could also indicate that cleaning is
required.
For installations where a pH BOSS is installed in the
same pipeline (as per INSTALLATION section), the
acid will often eliminate the need for cleaning
entirely.
Cleaning Procedure
!
Always wear gloves, eye protection and
protective clothing when handling acid.
!
Prepare a bucket of diluted pool acid. We
recommend to use a standard 10 Litre bucket. Fill
with around 4 Litres of water FIRST, then add
around 0.5 Litres of pool acid. ALWAYS ADD ACID
TO A LARGER VOLUME OF WATER. NEVER ADD
WATER TO ACID.
!
Unscrew the two barrel union nuts. Hold the
Oxidizing Pod in place to ensure that it does not
drop onto the ground when removing the barrel
union nuts.
!
Place the Oxidizing Pod into the diluted acid for 15
to 30 minutes, or until the deposits have been
visibly dissolved off.
!
Remove the Oxidizing Pod from the cleaning
solution and RINSE ALL OUTSIDE SURFACES
WELL WITH FRESH WATER. The diluted acid will
not affect the electrical connections as long as the
Oxidizing Pod is rinsed well.
!
To dispose of the used diluted acid cleaning
solution, simply tip the bucket into the pool. Rinse
the bucket well with fresh water.
!
Re- in sta ll t h e Ox id iz in g Po d a s p er t h e
INSTALLATION section.
MAINTENANCE
12
INSTRUCTION BOOK